Single Turn Wave Spring Overlap Type

Product details

Single-layer wave springs can be used in many occasions, mainly for short-stroke and medium-to-low load occasions. Can provide reliable and accurate linear load output. The free end of the gapped notched wave spring allows the outer diameter of the spring to expand during compression. If the spring is constrained in the hole, it will not cause jamming caused by the stamped closed wave washer. This design greatly improves the resistance. Fatigue performance and service life. Thereby effectively reducing costs.

Single-layer wave springs are divided into notched wave springs and overlap wave springs. SIBOLI is set to: VSSB/VSSR/VSSR-N series.

Notched and overlap wave springs are designed to match the bearing size. Carbon steel and stainless steel can be used as raw materials to produce products with diameters from 9mm to 600mm.

Radial changes: For example, the outer diameter of a notched wave spring will fit a 0.020 gap on each side of the hole. Its inner diameter will be 0.010 clear on each side of the shaft. When the spring deforms, the outer and inner diameters become larger and larger until the outer diameter contacts the cavity. When the outer diameter is against the wall of the cavity, the continued deformation causes the two ends of the gap to get closer and closer. Overlap wave springs allow similar deformations.

The overlap type wave spring is aligned with the notch type, which can better improve the production efficiency and effectively reduce the cost.

We have a one-to-one after-sales service system, and we can put the future trending technology of Single Turn Wave Spring Overlap Type industry for free coaching. We innovate the development of institutional mechanisms and broaden a variety of financing channels through the capital market. Our company has creative and innovative design team and exquisite craftsmanship, so that your products can maximize the achievement you expect.

http://www.metal-ring.com/